Creaks parquet board what to do indiscriminately

Each design tends to deteriorate in its own properties over time. However, at the same time, users should have special knowledge that will help get rid of any malfunctions that have arisen. Thus, in this article we will analyze the situation in which parquet acquires various defects, and also consider what needs to be done to eliminate it.

Why does a parquet board creak when walking

In the present case, there can be many different sources of trouble. Therefore, below will be presented the most common of all:

1. Due to the poor foundation, peeling of surfaces can form, thereby destroying the main part. Particularly popular is laying flooring material directly on cement. That is, if you did not use intermediate layers in the installation, then you will probably encounter this problem.
2. If your screed forms a maximum of two millimeters, then the destruction will be due to bumps.
3. Also, the problem may be hiding in the loose arrangement of the fiberboard.
4. Most often, masters make mistakes directly, not only during the installation process, but also when acquiring one or another source material.
5. And some of them do not follow standard rules at all.

REFERENCE! This may include the lack of necessary gaps between the coating and the wall.

1. Wrong arrangement of lags can also cause creaks.
2. If there is high humidity in the corresponding room, then due to non-observance of a certain regime, wood may narrow. Therefore, a characteristic sound is formed.

How to get rid of a creak without dismantling the board

After possible sources are considered, it is possible to start actions on their liquidation.

• If you rely on the cheapest way, then you have to arm yourself with self-tapping screws. With their help, you need to install a replacement for old nails.
• In addition, there is a more radical method. At the same time, it is worthwhile to know the distance, which is between the board itself and the concrete coating itself. To do this, you will have to drill a small sized recess and insert the wire there. Thus, it is possible to determine the gap. Further, corresponding to this length, self-tapping screws should be purchased. Then you need to find the location of the lags. Most often they are along a series of nails. Now you can proceed to the main stage. Again, drill a hole. It should be less than the diameter of the screw used by about one millimeter. Then you need to tighten the last of these products to the stop.

ATTENTION! The described manipulations must be performed with each board, and each lag must be involved.

• You can also use another option for the outcome of events. In this case, it is only necessary to acquire parts whose parameters correspond to the distance from concrete to the surface. Actually, their presence will serve as a support, which will reduce the load from other parts of the structures.

In any case, it is not recommended to use the fastening of the lags to the concrete structure.