It's no secret that the quality of water in urban apartments and country houses leaves much to be desired. The reasons for this are different, but to bring it back to normal they use the same method - filtering. That is, on the supply line, set a set of filters. As a rule, each filter is designed to solve a specific problem. Some remove mechanical impurities, some remove excess calcium.
Filter Installation Procedure
As a rule, several filters are used for complete water purification. But when installing them, a certain order must be followed.
Preparatory stage
Before installing the devices, you will need to do some work to prepare the site. A set of cleaning devices can be placed directly under the sink, for the most part this place is always empty or occupied by all kinds of junk. If we are talking about a country house, then they can be installed in the same room through which water was introduced into the house. Only then is the dilution of purified water at home.
Filters that are used in modern cleaning systems allow you to install them in two main ways:
- vertically;
- horizontally.
When choosing a place for their installation, remember that the cartridges are subject to periodic replacement. That is, they must be installed so that free access to the cartridges is provided for maintenance and replacement.
We prepare the necessary tools and materials
To install the filters, you will need to prepare the holes in the wall where the bracket will be installed on which the water purification devices are mounted. Companies producing such products make life easier for consumers by producing products that include several filters at once. They are installed on one bracket and it just needs to be fixed in the chosen place. As a rule, the necessary fasteners are included in the delivery. The tool you need to replace the cartridges is also included.
IMPORTANT!
CARTRIDGES INTENDED FOR CLEANING, SHOULD CHANGE AS MINIMUM ONCE ONE MONTH. OTHERWISE, UNDERSTANDING LIQUID WILL COME INTO THE HOUSEB.
How to install filters for water purification: step by step instructions
The sequence of operations for installing filters is as follows:
- Stop the water supply.
- Drain the remaining water in the pipe.
- On a previously prepared place, install the bracket for installing filters.
- Replace the filters and connect the piping.
Performing this operation should be guided by the requirements of the filter operating instructions.
If it comes to installing individual filters, then, in addition to their mounting on a wall or floor, it is necessary to observe the sequence of their installation. The first to install coarse and fine filters. They are designed to remove mechanical impurities. Following them, they install coal and other cleaning devices.
Leave Your Comment